DAQ-STC: Counting Events Using Easy-Level VIs
PrintDownloads
Filename: count_events-easy__daq-stc_.zip
Requirements: View
INSTRUCTIONS
1. Enter the device number of your board.
2. Enter the counter number.
3. Make the appropriate I/O connections as explained below.
4. Run the VI.
KEY PARAMETERS
This VI uses the easy-level Count Events or Time.vi to count TTL rising edges. The first time this subVI is called in the while loop the iteration "i" is zero, and the counter starts counting. Each successive call of the subVI reads the count. The small loop delay is used to free up processor time of your computer. Pressing the STOP button resets the counter.
I/O CONNECTIONS
Connect your TTL signal to be counted to the SOURCE pin of the chosen counter.
To find the actual pin numbers, refer to the hardware user manual.
DAQ VIS USED
Count Events or Time.vi
Requirements
Filename: count_events-easy__daq-stc_.zip
Software Requirements
Application Software: LabVIEW Full Development System 5.0.1
Language(s): LabVIEW
Hardware Requirements
Hardware Group: Multifunction DAQ (MIO)
Driver: Traditional NI-DAQ (Legacy)
Reader Comments | Submit a comment »
Legal
This example program (this "program") was developed by a National Instruments ("NI") Applications Engineer. Although technical support of this program may be made available by National Instruments, this program may not be completely tested and verified, and NI does not guarantee its quality in any way or that NI will continue to support this program with each new revision of related products and drivers. THIS EXAMPLE PROGRAM IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND AND SUBJECT TO CERTAIN RESTRICTIONS AS MORE SPECIFICALLY SET FORTH IN NI.COM'S TERMS OF USE (http://ni.com/legal/termsofuse/unitedstates/us/).