Performing Two Simultaneous DSA Measurements in FFT Analyzer Mode
Downloads
Filename: nidsa_two_measurements.zip
Requirements: View
To use this example, connect signals to analog input channels 0 and 1. In general, you get the most meaningful time-domain data by disabling dB units and looking at only the real portion of the values. For analyzing frequency-domain measurements, it is usually best to display signal magnitudes in dB units.
For windowing, baseband span, and averaging, use the controls on the left side of the interface panel. You must click the Reconfigure button for changes made to these settings to take effect.
Requirements
Filename: nidsa_two_measurements.zip
Software Requirements
Application Software: LabWindows/CVI Full Development System 5.0.1
Language(s): C
Hardware Requirements
Hardware Group: Dynamic Signal Analyzers (DSA)
Hardware Model: PXI-4552, PXI-4551, PCI-4552, PCI-4551
Driver: NI-DSA 1.1.1
Reader Comments | Submit a comment »
Legal
This example program (this "program") was developed by a National Instruments ("NI") Applications Engineer. Although technical support of this program may be made available by National Instruments, this program may not be completely tested and verified, and NI does not guarantee its quality in any way or that NI will continue to support this program with each new revision of related products and drivers. THIS EXAMPLE PROGRAM IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND AND SUBJECT TO CERTAIN RESTRICTIONS AS MORE SPECIFICALLY SET FORTH IN NI.COM'S TERMS OF USE (http://ni.com/legal/termsofuse/unitedstates/us/).
