NI-DAQmx Base: Read Digital Line in LabVIEW
PrintThis example shows how to dynamically read a single digital line with the NI-DAQmx Base commands. It accomplishes this by parsing out the desired line from the data read on the digital port.
Instructions for Running:
1. Configure the NI-DAQmx Base device.
2. Connect the signal lines to the device.
3. Select the digital port and line on the DAQ device to be read.
4. Run the program.
5. Stop the program when finished.
Reader Comments | Submit a comment »
Legal
This example program (this "program") was developed by a National Instruments ("NI") Applications Engineer. Although technical support of this program may be made available by National Instruments, this program may not be completely tested and verified, and NI does not guarantee its quality in any way or that NI will continue to support this program with each new revision of related products and drivers. THIS EXAMPLE PROGRAM IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND AND SUBJECT TO CERTAIN RESTRICTIONS AS MORE SPECIFICALLY SET FORTH IN NI.COM'S TERMS OF USE (http://ni.com/legal/termsofuse/unitedstates/us/).