NI-IMAQ I/O Simple Pulse Width Measurement
PrintOverview
This VI measures the pulse width of the input signal for use on a NI-IMAQ I/O FPGA device.
Downloads
Filename: imaq_io_pulse_width_simple.vi
Requirements: View
This VI measures the pulse width of the input signal for use on a NI-IMAQ I/O FPGA device.
Instructions for running:
1. Create a new LabVIEW project.
2. Add a NI-IMAQ I/O FPGA target to the project.
3. Add the example VI under your FPGA target.
4. Open and run the VI from the project.
Note:
To make this VI hardware specific add this VI to your FPGA target in your LabVIEW Project and replace the Input, Polarity, and Latch boolean controls with a FPGA I/O Node.
Requirements
Filename: imaq_io_pulse_width_simple.vi
Software Requirements
Application Software: LabVIEW Full Development System 8.2
Toolkits and Add-Ons: LabVIEW FPGA Module 8.2
Language(s): LabVIEW
Hardware Requirements
Hardware Group: Vision (IMAQ)
Hardware Model: NI PCIe-8254R, PCI-8254R, NI PCIe-8255R
Driver: NI-IMAQ 3.5.1
Reader Comments | Submit a comment »
Legal
This example program (this "program") was developed by a National Instruments ("NI") Applications Engineer. Although technical support of this program may be made available by National Instruments, this program may not be completely tested and verified, and NI does not guarantee its quality in any way or that NI will continue to support this program with each new revision of related products and drivers. THIS EXAMPLE PROGRAM IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND AND SUBJECT TO CERTAIN RESTRICTIONS AS MORE SPECIFICALLY SET FORTH IN NI.COM'S TERMS OF USE (http://ni.com/legal/termsofuse/unitedstates/us/).