NI 5102 Toggle PFI lines (high to low)
Print
This example demonstrates how to use the PFI lines of the NI 5102 to send a TTL logic high and low signal from the board. This is not a well known feature of the board and documentation on how it is done is scarce. The vi simply uses the Route Signal.vi (an advanced DAQ vi) to route either a TTL high or low to either PFI 1 or 2 of the NI 5102 device that is installed in your computer. The rest of the example is stolen from the NI Scope 2.0 shipping example "Configured Acquisition" and help is provided in the documentation of the vi.
Filename: 200125.vi
Application Software: LabVIEW Full Development System 6.0
Language(s): LabVIEW
Hardware Group: High-Speed Digitizers (Scopes)
Driver: NI-SCOPE 2.0
Requirements
Filename: 200125.vi
Software Requirements
Application Software: LabVIEW Full Development System 6.0
Language(s): LabVIEW
Hardware Requirements
Hardware Group: High-Speed Digitizers (Scopes)
Driver: NI-SCOPE 2.0
Reader Comments | Submit a comment »
Legal
This example program (this "program") was developed by a National Instruments ("NI") Applications Engineer. Although technical support of this program may be made available by National Instruments, this program may not be completely tested and verified, and NI does not guarantee its quality in any way or that NI will continue to support this program with each new revision of related products and drivers. THIS EXAMPLE PROGRAM IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND AND SUBJECT TO CERTAIN RESTRICTIONS AS MORE SPECIFICALLY SET FORTH IN NI.COM'S TERMS OF USE (http://ni.com/legal/termsofuse/unitedstates/us/).