Using the 3D Curve Graph
For example, the following 25 coordinates create the 3D curve shown:
0.00, 0.00, -2.04 0.26, 0.07, -2.02 0.46, 0.26, -1.97 0.55, 0.55, -1.89 0.51, 0.88, -1.77 0.32, 1.20, -1.62 0.00, 1.44, -1.44 -0.42, 1.56, -1.24 -0.88, 1.53, -1.02 -1.33, 1.33, -0.78 -1.71, 0.99, -0.53 -1.95, 0.52, -0.27 -2.04, 0.00, 0.00 -1.95, -0.52, 0.27 -1.71, -0.99, 0.53 -1.33, -1.33, 0.78 -0.88, -1.53, 1.02 -0.42, -1.56, 1.24 0.00, -1.44, 1.44 0.32, -1.20, 1.62 0.51, -0.88, 1.77 0.55, -0.55, 1.89 0.46, -0.26, 1.97 0.26, -0.07, 2.02 0.00, 0.00, 2.04 | ![]() |
To use the 3D contour graph, place the control (Graph->3D Curve Graph) on your front panel. This creates the ActiveX control and the associated Plot 3D Curve VI:

Figure 1.
Then, simply wire up three arrays containing the X, Y, and Z coordinates of each point in the curve.
Reader Comments | Submit a comment »
Legal
This tutorial (this "tutorial") was developed by National Instruments ("NI"). Although technical support of this tutorial may be made available by National Instruments, the content in this tutorial may not be completely tested and verified, and NI does not guarantee its quality in any way or that NI will continue to support this content with each new revision of related products and drivers. THIS TUTORIAL IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND AND SUBJECT TO CERTAIN RESTRICTIONS AS MORE SPECIFICALLY SET FORTH IN NI.COM'S TERMS OF USE (http://ni.com/legal/termsofuse/unitedstates/us/).

