Single-Board RIO Training Module
PrintOverview
Welcome to the NI Single-Board RIO introductory training module. This free training will guide you through several examples and exercises to show you how to begin programming NI Single-Board RIO.
Preface
This tutorial is compiled for and designed to work with the NI Single-Board RIO hardware that is included in the NI Embedded Software Evaluation Kit. That kit includes an NI Single-Board RIO, a signal accessory daughter card for example I/O, a power supply, cables, and all documentation and accessories you would need to get started. The exercises and examples in the tutorial could also work with any sbRIO-961x/963x/964x with the EvalRIO-02 signal accessory daughtercard.
This tutorial assumes very little previous knowledge of LabVIEW or NI RIO hardware architecture. If you are already familiar with LabVIEW and programming NI CompactRIO, NI Single-Board RIO is based on the same architecture, so you already have the skills needed to create applications with NI Single-Board RIO.
System Requirements
This tutorial requires the following hardware and software components for completion: (All components are included in NI Embedded Software Evaluation Kit)
- Software
- LabVIEW Development System
- LabVIEW Real-Time Development Module
- LabVIEW FPGA Development Module
- Hardware
- NI Single-Board RIO (sbRIO-961x/3x/4x)
- EvalRIO-02 signal accessory daugthercard
- Power supply and Ethernet cable
Reader Comments | Submit a comment »
Legal
This tutorial (this "tutorial") was developed by National Instruments ("NI"). National Instruments does not support this tutorial or guarantee its quality in any way. THIS TUTORIAL IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND AND SUBJECT TO CERTAIN RESTRICTIONS AS MORE SPECIFICALLY SET FORTH IN NI.COM'S TERMS OF USE (http://ni.com/legal/termsofuse/unitedstates/us/).