Academic Company Events NI Developer Zone Support Solutions Products & Services Contact NI MyNI
What is Developer Zone?
You have browsed by [remove all]

Content Type
: Example [remove]
Product
: Instrument Connectivity / Serial [remove]

1-10 of 122 results
  rss
Sort items by:

JTAG communication
I have a motor control board with me with Altera FPGA on it. Currently I program the FPGA with firmware using RS485 communication. However this is very slow & I need to use JTAG communication for faster programming.
Software: LabVIEW Full Development System

MPI S7 Protocol Example
This content (includes attachments) has been made available by community members, whom are solely responsible for such content. National Instruments does not support this content, and does not guarantee its quality in any way.
Software: LabVIEW Base Development System

Opto22 Ultimate I/O Controlled by cRIO using Modbus TCP
The attached example was designed as a Proof of Concept by an Applications Engineer at National Instruments. It is intended to prove that CompactRIO could be used as the intelligent center of a larger network of Modbus Slave PAC's.
Software: LabVIEW Professional Development System
Hardware: CompactRIO, Real-Time

Reading a LM92 temperature sensor using a PIC16F877 and LabView
Reading a LM92 temperature sensor using a PIC16F877 and LabView is a Example - [#document: null]
Software: LabVIEW Base Development System

Reading a LM73 temperature sensor using a PIC16F877 and LabView
Reading a LM73 temperature sensor using a PIC16F877 and LabView is a Example - [#document: null]
Software: LabVIEW Base Development System

Reference Example: Digital Switch Matrix 64x64 (FPGA Module)
Acts as a dynamic 64x64 bit digital switch matrix. Any of the 64 inputs can be connected to any of the outputs. A single input can drive multiple outputs. The matrix of connections from input to output can be remapped on the fly without recompiling the FPGA VI.
Software: LabVIEW Professional Development System
Hardware: Reconfigurable I/O

E3631A Power Supply GUI
An advantge of using the E3631A Power Supply GUI is that one can choose a step size to vary the voltage or current levels. You can step the voltage on the +6 Terminal as small as 500uv. Plus the current and voltage readback is much easier to read then just looking the front panel of the supply.
Software: LabVIEW Full Development System

Agilent E3631A triple output DC Power Supply Front Panel
Agilent E3631A triple output DC Power Supply Front Panel is a Example - [#document: null]
Software: LabVIEW Full Development System

Simulating a GPIB Instrument in LabVIEW
This example shows how to use a GPIB board as a non-controller to simulate a GPIB instrument in LabVIEW. In "non-controller.vi", the GPIB interface is configured to be the non-controller and is assigned a primary address.
Software: LabVIEW Professional Development System
Hardware: GPIB

CompactRIO Simultaneous AI and AO Streaming
This example shows how to simultaneously stream AI and AO data between the RT controller and FPGA on a 9002/4 controller using a NI 9215 module for analog input and NI 9263 module for analog output.
Software: LabVIEW Full Development System, LabVIEW Professional Development System
Hardware: CompactRIO

1-10 of 122 results
  rss