You are here: NI Home > Support > Product Reference > Manuals > NI High Speed Digitizers Help

This section contains information on programming NI high-speed digitizers.

You can acquire data with an NI high-speed digitizer either programmatically or interactively.

Programmatically Acquiring Data using NI-SCOPE.

If you want to integrate a digitizer into your test and measurement application, you can program the device using National Instruments LabVIEW or LabWindows/CVI, C/C++, or Microsoft Visual Basic.

The following figure illustrates the relationship between your programming environment, NI-DAQ, and the digitizer.

Interactively Acquiring Data with the Scope Soft Front Panel

If you are using the digitizer as a general-purpose digitizer, you can use the Scope Soft Front Panel (SFP) to make measurements interactively without writing code. The Scope SFP is a software application for NI high-speed digitizers. The Scope SFP is a full-featured, easy-to-use interface with 40 waveform measurements that you can use immediately without learning a programming language.

To launch the Scope SFP, go to Start»Programs»National Instruments» NI-SCOPE»Scope Soft Front Panel.

For more information, refer to the Scope Soft Front Panel Help.