|NI-DCPower (English | Japanese)|
Short Name: Sequence Advance Trigger Digital Edge - Input Terminal
Property of niDCPower
Specifies the input terminal for the Sequence Advance trigger. This property is used only when the Sequence Advance Trigger Type property is set to Digital Edge.
|Note This property is not supported by all devices. Refer to Supported Properties by Device for information about supported devices.|
You can specify any valid input terminal for this property. Valid terminals are listed in Measurement & Automation Explorer under the Device Routes tab. For the PXIe-4162/4163, refer to the Signal Routing topic for the device to determine which routes are available. This information is not available on a Device Routes tab in MAX.
Input terminals can be specified in one of two ways. If the device is named Dev1 and your terminal is PXI_Trig0, you can specify the terminal with the fully qualified terminal name, /Dev1/PXI_Trig0, or with the shortened terminal name, PXI_Trig0. The input terminal can also be a terminal from another device. For example, you can set the input terminal on Dev1 to be /Dev2/SourceCompleteEvent.
The following table lists the characteristics of this property.
|High-level VIs||niDCPower Configure Digital Edge Sequence Advance Trigger|