|NI-DCPower (English | Japanese)|
Short Name: Start Trigger Digital Edge - Input Terminal
Property of niDCPower
Specifies the input terminal for the Start trigger. This property is used only when the Start Trigger Type property is set to Digital Edge.
|Note This property is not supported by all devices. Refer to Supported Properties by Device for information about supported devices.|
You can specify any valid input terminal for this property. Valid terminals are listed in Measurement & Automation Explorer under the Device Routes tab. For the PXIe-4162/4163, refer to the Signal Routing topic for the device to determine which routes are available. This information is not available on a Device Routes tab in MAX.
Input terminals can be specified in one of two ways. If the device is named Dev1 and your terminal is PXI_Trig0, you can specify the terminal with the fully qualified terminal name, /Dev1/PXI_Trig0, or with the shortened terminal name, PXI_Trig0. The input terminal can also be a terminal from another device. For example, you can set the input terminal on Dev1 to be /Dev2/SourceCompleteEvent.
The following table lists the characteristics of this property.
|High-level VIs||niDCPower Configure Digital Edge Start Trigger|