|NI-DCPower (English | Japanese)|
ViStatus niDCPower_ConfigureApertureTime(ViSession vi, ViConstString channelName, ViReal64 apertureTime, ViInt32 units);
Configures the aperture time on the specified channel(s).
|Note This function is not supported on all devices. Refer to Supported Functions by Device for more information about supported devices.|
The supported values depend on the units. Refer to the Aperture Time topic for your device in the NI DC Power Supplies and SMUs Help for more information. In general, devices support discrete apertureTime values, and if you configure apertureTime to some unsupported value, NI-DCPower coerces it up to the next supported value.
Refer to the Measurement Configuration and Timing or DC Noise Rejection topic for your device in the NI DC Power Supplies and SMUs Help for more information about how to configure your measurements.
|vi||ViSession||Identifies a particular instrument session. vi is obtained from the niDCPower_InitializeWithChannels function.|
|channelName||ViConstString||Specifies the output channel(s) to which this configuration value applies. Specify multiple channels by using a channel list or a channel range. A channel list is a comma (,) separated sequence of channel names (for example, 0,2 specifies channels 0 and 2). A channel range is a lower bound channel followed by a hyphen (-) or colon (:) followed by an upper bound channel (for example, 0-2 specifies channels 0, 1, and 2). In the Running state, multiple output channel configurations are performed sequentially based on the order specified in this parameter.|
|apertureTime||ViReal64||Specifies the aperture time. Refer to the Aperture Time topic for your device in the NI DC Power Supplies and SMUs Help for more information.|
|units||ViInt32||Specifies the units for apertureTime.|
|Status||ViStatus||Reports the status of this operation. To obtain a text description of the status code, call the niDCPower_error_message function. To obtain additional information concerning the error condition, call the niDCPower_GetError function.|