Active Plot Area Property
Property of MixedSignalGraph.
Gets or sets the active plot area. After you get or set the active plot area, you then can set properties and methods that affect only the specified plot area.
Remarks
The following table lists the characteristics of this property.
| Settable when the VI is running | Yes |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Loads the front panel into memory | Yes |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Read/Write |
Resources
My Profile | Privacy | Legal | Contact NI © 2006 National Instruments Corporation. All rights reserved. | 
E-Mail this Page
E-Mail this Page