You are here: NI Home > Support > Product Reference > Manuals > LabVIEW 8.2 Help

Property of Variable.

Gets or sets the HI alarm deadband as a percentage of the full scale range. To use this property, you must install the LabVIEW Datalogging and Supervisory Control Module. A shared variable does not return to a normal state until it has left the alarm condition set by the value of the Alarming:Hi:Level property by at least the value of the deadband. If you set the deadband too high, the shared variable value might not clear the alarm.

Note  You can enable alarming only for network-published shared variables.

This property is similar to the Deadband option on the Configure Alarms dialog box.

Remarks

The following table lists the characteristics of this property.

Settable when the VI is running	Yes
Need to authenticate before use	No
Loads the block diagram into memory	No
Remote access disallowed	No
Loads the front panel into memory	No
Must wait until user interface is idle	No
Available with control VIs	No
Available with global VIs	No
Available with strict type definitions	No
Available with polymorphic VIs	No
Available in Run-Time Engine and Real-Time Operating System	No
Permissions	Read/Write