You are here: NI Home > Support > Product Reference > Manuals > LabVIEW 8.2 Help

Property of Variable.

Gets or sets the value, in engineering units, that evokes the HI alarm condition for a shared variable. To use this property, you must install the LabVIEW Datalogging and Supervisory Control Module. The shared variable remains in the alarm state until the shared variable value goes below this value minus the deadband value.

Note  You can enable alarming only for network-published shared variables.

This property is similar to the Limit option on the Configure Alarms dialog box.

Remarks

The following table lists the characteristics of this property.

Settable when the VI is running	Yes
Need to authenticate before use	No
Loads the block diagram into memory	No
Remote access disallowed	No
Loads the front panel into memory	No
Must wait until user interface is idle	No
Available with control VIs	No
Available with global VIs	No
Available with strict type definitions	No
Available with polymorphic VIs	No
Available in Run-Time Engine and Real-Time Operating System	No
Permissions	Read/Write