Scale Fit Property
Property of GraphScale.
Fit scale to data: 0-Do not autoscale, 1-Autoscale once now, 2-Autoscale.
This property applies only to the active X-scale or active Y-scale.
This property is similar to the AutoScale items on the shortcut menu of an x- or y-scale.
This property is similar to the Autoscale checkbox on the Scales page of the Properties dialog box.
Remarks
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Read/Write |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |
Resources
My Profile | Privacy | Legal | Contact NI © 2006 National Instruments Corporation. All rights reserved. | 
E-Mail this Page
E-Mail this Page