Cutoff Property (Not in Base Package)
Property of SceneLight.
Reads or writes the cutoff you apply to a spotlight to restrict the width of the light. The value you wire to this property is equivalent to half the angle of the actual spotlight. For example, if you want the spotlight to emit a 40 degree angle of light, set this property to 20. This property accepts values 0 to 90 and 180, where 180 represents no cutoff.
Remarks
The following table lists the characteristics of this property.
| Available in Run-Time Engine and Real-Time Operating System | Yes |
| Permissions | Write In Edit Only |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |
Resources
My Profile | Privacy | Legal | Contact NI © 2006 National Instruments Corporation. All rights reserved. | 
E-Mail this Page
E-Mail this Page