Remove VI Method (Not in Base Package)
Method of SubPanel.
Unloads the VI in the subpanel control. If no references to the VI remain, LabVIEW removes the VI from memory. If references to the VI remain and the VI stays in memory, this method does not change the state of the VI.
Remarks
The following table lists the characteristics of this method.
| Available in Run-Time Engine and Real-Time Operating System | Yes (Read/Write) |
| Settable when the VI is running | Yes |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |
Resources
My Profile | Privacy | Legal | Contact NI © 2006 National Instruments Corporation. All rights reserved. | 
E-Mail this Page
E-Mail this Page