Refresh Dependencies Method
Method of TargetItem.
Refreshes Dependencies under this target in the Project Explorer window. You also can use the Project Explorer window to refresh Dependencies.
 | Note The LabVIEW Datalogging and Supervisory Control Module supports this method in the Run-Time Engine. |
Remarks
The following table lists the characteristics of this method.
| Available in Run-Time Engine and Real-Time Operating System | No |
| Settable when the VI is running | No |
| Loads the front panel into memory | No |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access disallowed | No |
| Must wait until user interface is idle | No |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |
Resources
My Profile | Privacy | Legal | Contact NI © 2006 National Instruments Corporation. All rights reserved. | 
E-Mail this Page
E-Mail this Page