Short Name: Save
Requires: Base Development System
Class: Project Methods
To Use: Create a method.
Saves the LabVIEW project to the path that the project was previously saved to or loaded from or to a specified path.
If the project has not been saved and the value of the Path parameter is <Not A Path> or Path is unwired, this method returns an error. You also can select File»Save Project to save the project.
|Note The LabVIEW Datalogging and Supervisory Control Module supports this method in the Run-Time Engine.|
|Path||Yes||Path to the project.|
The following table lists the characteristics of this method.
|Data type||No return value|
|Available in Run-Time Engine||No|
|Available in Real-Time Operating System||No|
|Settable when the VI is running||No|
|Loads the front panel into memory||No|
|Need to authenticate before use||No|
|Loads the block diagram into memory||No|
|Remote access allowed||Yes|
|Must wait until user interface is idle||No|
|Available with control VIs||No|
|Available with global VIs||No|
|Available with strict type definitions||No|
|Available with polymorphic VIs||No|