Short Name: Cutoff
Requires: Full Development System
Class: SceneLight Properties
To Use: Create a property.
Reads or writes the cutoff you apply to a spotlight to restrict the width of the light. The value you wire to this property is equivalent to half the angle of the actual spotlight. For example, if you want the spotlight to emit a 40 degree angle of light, set this property to 20. This property accepts values 0 to 90 and 180, where 180 represents no cutoff.
The following table lists the characteristics of this property.
|Available in Run-Time Engine||Yes|
|Available in Real-Time Operating System||No|
|Settable when the VI is running||Yes|
|Loads the front panel into memory||No|
|Need to authenticate before use||No|
|Loads the block diagram into memory||No|
|Remote access allowed||Yes|
|Must wait until user interface is idle||No|
|Available with control VIs||No|
|Available with global VIs||No|
|Available with strict type definitions||No|
|Available with polymorphic VIs||No|