Short Name: Alarming.U32BitField.AlarmOn
Requires: Base Development System
Class: Variable Properties
To Use: Create a property.
Gets or sets whether a shared variable generates an alarm when any bit (1) is in alarm state or only when all bits (0) are in alarm state. To use this property, you must install the LabVIEW Datalogging and Supervisory Control Module.
This option is valid only when the Alarming:U32BitField:Enabled property is TRUE.
|Note You can enable alarming only for network-published shared variables.|
This property is similar to the Alarm On option on the Alarming page of the Shared Variable Properties dialog box.
The following table lists the characteristics of this property.
|Available in Run-Time Engine||No|
|Available in Real-Time Operating System||No|
|Settable when the VI is running||Yes|
|Loads the front panel into memory||No|
|Need to authenticate before use||No|
|Loads the block diagram into memory||No|
|Remote access allowed||Yes|
|Must wait until user interface is idle||No|
|Available with control VIs||No|
|Available with global VIs||No|
|Available with strict type definitions||No|
|Available with polymorphic VIs||No|