Short Name: Network.AccessType
Requires: Base Development System
Class: Variable Properties
To Use: Create a property.
Specifies whether a shared variable reads, writes, or reads and writes data.
Valid values are 0 (read only), 1 (write only), and 2 (read/write).
If you set this property to 0 (read only) or 1 (write only), you can create shared variables that are configured only to read data or write data, respectively. When you right-click a shared variable that is bound to a source that is read or write only, the Change to Write and Change to Read options are disabled in the shortcut menu.
An error occurs if you attempt to set this property when the VI is running.
The following table lists the characteristics of this property.
|Available in Run-Time Engine||No|
|Available in Real-Time Operating System||No|
|Settable when the VI is running||Yes|
|Loads the front panel into memory||No|
|Need to authenticate before use||No|
|Loads the block diagram into memory||No|
|Remote access allowed||Yes|
|Must wait until user interface is idle||No|
|Available with control VIs||No|
|Available with global VIs||No|
|Available with strict type definitions||No|
|Available with polymorphic VIs||No|