Short Name: RT.UseBuffering
Requires: Base Development System
Class: Variable Properties
To Use: Create a property.
If TRUE, LabVIEW uses the configuration you specify in the Use Buffering section of the Network page of the Shared Variable Properties dialog box to configure the size and elements of a real-time first-in-first-out (FIFO) buffer for a shared variable. The default is FALSE. You can only use this property in the LabVIEW development system, but you must install the LabVIEW Real-Time Module to make this property available.
An error occurs if you attempt to set this property when the VI is running.
The following table lists the characteristics of this property.
|Available in Run-Time Engine||No|
|Available in Real-Time Operating System||No|
|Settable when the VI is running||Yes|
|Loads the front panel into memory||No|
|Need to authenticate before use||No|
|Loads the block diagram into memory||No|
|Remote access allowed||Yes|
|Must wait until user interface is idle||No|
|Available with control VIs||No|
|Available with global VIs||No|
|Available with strict type definitions||No|
|Available with polymorphic VIs||No|