Short Name: Connect Wires
Requires: VI Scripting
Class: Node Methods
To Use: Create a method.
Connects wires to the node. The wire source can be either another node or a terminal. Auto wire applies only if the source is a node. If auto wire is TRUE, compatible terminals are chosen automatically from the source node to be wired to the terminals of the node. Wiring specs is a 2D array of strings that specify the names of the source and sink terminal pairs.
|Wire Source||Yes||The original source of the wire.|
|Auto Wire? (T)||No||If TRUE, LabVIEW automatically chooses a compatible source terminal from the source node. You can use auto-wiring only if the source is a node.|
|Wiring Specs||No||A 2D array of strings that specify the names of the source and sink terminal pairs. You can use wiring specs only if the source is a node.|
|Auto Route? (F)||No||If TRUE, LabVIEW automatically finds the best path for the wire. The default is FALSE.|
The following table lists the characteristics of this method.
|Data type||No return value|
|Available in Run-Time Engine||No|
|Available in Real-Time Operating System||Yes|
|Settable when the VI is running||No|
|Loads the front panel into memory||No|
|Need to authenticate before use||No|
|Loads the block diagram into memory||No|
|Remote access allowed||Yes|
|Must wait until user interface is idle||No|
|Available with control VIs||No|
|Available with global VIs||No|
|Available with strict type definitions||No|
|Available with polymorphic VIs||No|