|LabVIEW 2016 Help|
|LabVIEW 2017 Help|
|LabVIEW 2018 Help|
|LabVIEW 2019 Help|
|LabVIEW 2020 Help|
Short Name: Conn Responsive.Info
Requires: Base Development System
Class: Application Methods
To Use: Create a method.
Gets and sets how often LabVIEW checks if a VI Server connection is responsive.
Set the PingDelay and PingTimeout parameters of this method to configure how LabVIEW checks the connection. If LabVIEW does not receive a message in the time you specify in PingDelay, LabVIEW sends a query to prompt the VI Server network connection for a message. After sending the query, if LabVIEW does not receive a message in the time you specified in PingTimeout, LabVIEW considers the connection unresponsive. Then, all VIs and functions waiting on the connection return network connection error code 1130.
For example, if you set PingDelay to 3000 and PingTimeout to 1000, LabVIEW sends a query to verify the status of the VI Server network connection every time 3 seconds elapse without LabVIEW receiving a message over the connection. If LabVIEW does not receive a reply from the network, LabVIEW waits 1 second before all VIs and functions waiting on the connection return network connection error 1130, which you can handle on the block diagram.
Default for PingDelay and PingTimeout is 10,000 ms, which means LabVIEW checks the connection every 10 seconds and waits up to 10 seconds for the connection to respond.
|Note If a network operation times out according to the timeout value you specify in PingTimeout, LabVIEW considers the connection unresponsive but does not close the connection. All current and future calls waiting on the connection return a connection error. LabVIEW does not send another message to query the connection status until LabVIEW considers the connection responsive again. A connection becomes responsive again when LabVIEW receives a message over the connection.|
|PingDelay||No||Specifies how long between queries LabVIEW waits, in milliseconds. If you specify a value of –1 (infinity) LabVIEW does not check the connection unless you use the Connection Responsiveness:Check method. If you want LabVIEW to check the connection, you must set PingDelay to a positive number or use the Connection Responsiveness:Check method.|
|PrevPingDelay||No||PingDelay in milliseconds you previously specified.|
|PingTimeout||No||Specifies how long in milliseconds before LabVIEW times out after LabVIEW sends a query to prompt the VI Server network connection for a message. If a timeout occurs, all VIs and functions waiting on the connection return a connection unresponsive error.|
|PrevPingTimeout||No||PingTimeout in milliseconds you previously specified.|
The following table lists the characteristics of this method.
|Data type||No return value|
|Available in Run-Time Engine||Yes (Read/Write)|
|Available in Real-Time Operating System||Yes|
|Remote access allowed||Yes|