|LabVIEW 2016 Help|
|LabVIEW 2017 Help|
|LabVIEW 2018 Help|
|LabVIEW 2019 Help|
|LabVIEW 2020 Help|
Short Name: AutoLog.AtFinish
Requires: Base Development System
Class: VI Properties
To Use: Create a property.
Indicates whether to write front panel values to a datalog file after the VI runs.
This method is similar to the Log at Completion item on the Operate menu.
|Note If you set Log at Finish without having set the Log File Path property, the next time this VI finishes executing, a dialog box appears prompting you to specify the file path.|
The following table lists the characteristics of this property.
|Available in Run-Time Engine||Yes|
|Available in Real-Time Operating System||Yes|
|Settable when the VI is running||Yes|
|Loads the front panel into memory||No|
|Need to authenticate before use||No|
|Loads the block diagram into memory||No|
|Remote access allowed||Yes|
|Must wait until user interface is idle||No|
|Available with control VIs||No|
|Available with global VIs||No|
|Available with strict type definitions||No|
|Available with polymorphic VIs||No|