|LabVIEW 2015 Help|
|LabVIEW 2016 Help|
|LabVIEW 2017 Help|
|LabVIEW 2018 Help|
|LabVIEW 2019 Help|
Short Name: AutoLog.Path
Requires: Base Development System
Class: VI Properties
To Use: Create a property.
Path of the datalog file in which front panel data and a time stamp are written.
|Note Use this property in conjunction with the Log at Finish property, which specifies whether to log the data. If you set the Log at Finish property without also setting this property, a dialog box appears at run time, prompting you to specify a file path.|
The following table lists the characteristics of this property.
|Available in Run-Time Engine||Yes|
|Available in Real-Time Operating System||Yes|
|Settable when the VI is running||Yes|
|Loads the front panel into memory||No|
|Need to authenticate before use||No|
|Loads the block diagram into memory||No|
|Remote access allowed||Yes|
|Must wait until user interface is idle||No|
|Available with control VIs||No|
|Available with global VIs||No|
|Available with strict type definitions||No|
|Available with polymorphic VIs||No|