|LabVIEW 2016 Help|
|LabVIEW 2017 Help|
|LabVIEW 2018 Help|
|LabVIEW 2019 Help|
|LabVIEW 2020 Help|
Short Name: FP.Run-Time Position.Maximized
Requires: Base Development System
Class: VI Methods
To Use: Create a method.
Configures a VI to maximize its front panel every time the VI runs. If the VI is running when you call this method, the change does not take effect until the next time the VI runs.
If you want to change the position of the VI while it is running, use the Front Panel Window:Window Bounds property instead.
|Monitor||No||Specifies the monitor on which the front panel window appears, if you have multiple monitors. The value 0 is the primary monitor and is the default value. If you specify a value other than 0, the VI runs on that monitor. If you specify a monitor number greater than the number of monitors on the system, or if you specify a negative number, LabVIEW returns an error. The monitor number corresponds to the video card you plug the monitor in to.|
The following table lists the characteristics of this method.
|Data type||No return value|
|Available in Run-Time Engine||Yes (Read/Write)|
|Available in Real-Time Operating System||No|
|Settable when the VI is running||Yes|
|Loads the front panel into memory||No|
|Need to authenticate before use||No|
|Loads the block diagram into memory||No|
|Remote access allowed||Yes|
|Must wait until user interface is idle||No|
|Available with control VIs||Yes|
|Available with global VIs||Yes|
|Available with strict type definitions||No|
|Available with polymorphic VIs||Yes|