Axiom CMD565 VxWorks ROM Example Target (Embedded Development Module)
This target configuration allows you to download an application you build with the Embedded Development Module into the external flash array. The application automatically starts after you power on or reset the board. The application you build is self-contained in the external flash memory.
Complete the following steps to download the application image to the external flash array.
- Configure the board as shown in the following figure. This is the default configuration that allows you to start the Axiom Monitor. Verify that CONFIG SWITCH 5 and 6 are set to ON to enable the internal flash array.
- Connect COM 1 to the available COM port on the host machine using a straight cable. A NULL modem cable does not work.
- Launch AxIDE or another communication program, Tera Term for example, and open a connection to the serial port. The communication settings are 9600, 8, N, 1, N.
- Power on the Axiom board. The Axiom Monitor appears.
- Press the <2> key to download to the internal flash memory.
- Press the <E> key to erase the internal flash array.
- Press the <P> key to program the internal flash array.
- Press the Upload button.
- Power off and configure the Axiom board as shown in the following figure. Change the communication speed of the terminal program to 57,600 bps.
Resources
- Creating the MPC566EVB, VxWorks Module Target for the LabVIEW Embedded Development Module- - NI Developer Zone
- Using the UNIX Console Target with the LabVIEW Embedded Development Module- Developer Zone - - NI Developer Zone
- Learn The Basics: LabVIEW Embedded Deployment Platforms- Developer Zone - NI Developer Zone