You are here: NI Home > Support > Product Reference > Manuals > LabVIEW Microprocessor SDK 2.5 Help

Complete the following steps to install the uCLinux image.

1. Install the P&E BDM interface drivers from the CD that comes with the evaluation board or download and install the drivers from the P&E Microcomputer Systems Web site at www.pemicro.com. National Instruments recommends downloading and installing the drivers. If the P&E BDM interface drivers are already installed, you do not need to reinstall the drivers.
2. Download and install the CF Flasher from the Freescale Web site at www.freescale.com/files/soft_dev_tools/software/programmers/CFFLASHER.zip.
3. Use a USB cable to connect the USB-ML-CF emulator to the M5329EVB board and the host computer. The emulator is included with the M5329EVB board. Windows should recognize the emulator and install the necessary drivers.
4. Power on the evaluation board.
5. Select Programs»CF Flasher 3.1 to launch CF Flasher. Refer to the CF Flasher help for more information about using CF Flasher.
6. Click the Target Config button in the CF Flasher main dialog box to open the Target Configuration dialog box.
7. Select M5329EVB from the Target Configuration drop-down list.
8. Select PE_USB_ML from the BDM Communication dialog box
9. Click the OK button to close the Target Configuration dialog box.
10. Click the Program button.
11. Unzip m5329evb.zip, located in the labview\Targets\NI\Embedded\unix\m5329evb\bin\ directory, to a temporary location.
12. Navigate to and select m5329evb.bin
13. When you are prompted for the start address, enter 0 and click the OK button.
14. Click the Program button.

Note  Installing the image can take a few minutes.

My Profile | Privacy | Legal | Contact NI   © 2009 National Instruments Corporation. All rights reserved.   |