Installing the RedBoot Bootloader (Embedded Development Module)
You must install the RedBoot bootloader on the phyCORE-ARM7/LPC229 x processor before you can use it. Complete the following steps to write the RedBoot bootloader.
- Install and start the LPC2000 Flash Utility, which is located on the PHYTEC CD.
- Connect the board using the first serial interface at P1A, which is the lower socket of the double DB-9 connector at P1.
- In the Filename text box, navigate to and select the redboot.hex file, which is located in the following directory:
labview\Targets\NI\Embedded\ecos\phytec_lpc229x\libs\redboot - Select LPC2294, XTAL Freq. [kHX]: 10000 from the Device list, which is the serial port on the host computer.
- Select 9600 from the Use Baud Rate list.
- Click the Upload to Flash button.
- On the board, press the Boot button to start the In-System Programmer (ISP) while you press the Reset button to reset the board.
Refer to the documentation on the PHYTEC CD that comes with the Rapid Development Kit for more information about writing the RedBoot bootloader.