You are here: NI Home > Support > Product Reference > Manuals > Sound and Vibration Measurement Suite 7.0 Help

Owning Palette: Configure Swept Sine (Traditional DAQ) VIs

Installed With: Sound and Vibration Measurement Suite. This topic might not match its corresponding palette in LabVIEW depending on your operating system, licensed product(s), and target.

Use the Configure Advanced Settings VIs to specify advanced configuration settings for swept-sine measurements.

The VIs on this palette can return ranges of LabVIEW error codes or specific sound and vibration error codes.

Palette Object	Description
SVT Set Swept Sine Block Duration	Configures the block duration of the swept-sine acquisition.
SVT Set Swept Sine Custom Frequencies	Configures the frequencies used for swept-sine measurements.
SVT Set Swept Sine DC Offset	Sets the DC bias on the AO channel during the sweep. This DC bias might be necessary for a specific DUT, and the DC value does not affect the swept sine computations.
SVT Set Swept Sine Propagation Delays	Sets the propagation time, expressed in number of samples, introduced by the data acquisition board used to perform the swept-sine measurement and the propagation time, expressed in milliseconds, introduced by the device under test (DUT).
SVT Set Swept Sine Repeat Mode	Sets whether the swept sine sweep runs once or automatically repeats after reaching the stop frequency.
SVT Set Swept Sine Sampling Frequency	Sets the sampling frequency for the swept-sine analyzer.

My Profile | Privacy | Legal | Contact NI   © 2009 National Instruments Corporation. All rights reserved.   |