Using C Series Modules in a LabVIEW Project

NI CompactRIO Device Drivers Help

Edition Date: December 2017

Part Number: 373197L-01

»View Product Info
Download Help (Windows Only)

To use C Series modules in a LabVIEW project, you need to configure the project with your controller, chassis, and FPGA. The following figure shows a project configured with a controller, chassis, FPGA target, and C Series modules in the Scan Interface and FPGA Interface.

1  Target   4  C Series Modules (Scan Interface)  
2  Chassis Item   5  FPGA Target  
3  Real-Time Scan Resources Item   6  C Series Module (FPGA Interface)  

Refer to the Using the Scan Interface with FPGA Interface LabVIEW project in the labview\examples\CompactRIO\NI Scan Engine\Getting Started\Using Scan Interface with FPGA Interface\Using Scan Interface with FPGA Interface.lvproj for an example of a LabVIEW project using C Series I/O.

Targets and Chassis Items

The following table shows the icons for the different targets and chassis items.

ObjectIconDevice
Targets

CompactRIO Controller

Ethernet RIO Chassis

Single-Board RIO Device
Chassis Items

CompactRIO Chassis, Ethernet RIO Chassis

MXIe-RIO Chassis

R Series Expansion Chassis, Single-Board RIO Mezzanine Card

Single-Board RIO Device

WAS THIS ARTICLE HELPFUL?

Not Helpful