Idle Interval (s) Property

NI WLAN Generation Toolkit 18.0 Help

Edition Date: October 2018

Part Number: 373725J-01

»View Product Info
Download Help (Windows Only)

Short Name: Idle Interval (s)

Property of niWLANGeneration

Specifies the interframe spacing for signal generation. If you set the Idle Interval Mode property to Split, the toolkit places half of the interframe spacing on either side of the burst in the generated waveform. If you set the Idle Interval Mode property to Post Burst, the toolkit places the interframe spacing at the end of the waveform. The waveform contains zeros for the duration of the interframe spacing. This value is expressed in seconds.

Tip  For higher values of idle interval, LabVIEW may run out of memory. For a large idle interval, you can create a small idle waveform and generate the waveform multiple times using scripting.

The default value is 100 microseconds. Valid values are 0 to 1, inclusive.

Remarks

The following table lists the characteristics of this property.

Datatype /images/reference/en-XX/help/373725J-01/cdbl.gif
PermissionsRead/Write
High-level VIs niWLANG Set Idle Interval
ResettableNo

WAS THIS ARTICLE HELPFUL?

Not Helpful