Company Events Academic Community Support Solutions Products & Services Contact NI MyNI

NI 9230/9232 Calibration Procedure

Calibration Executive 4.0 Help

Edition Date: March 2017

Part Number: 374564H-01

»View Product Info
Download Help (Windows Only)

This topic contains information for calibrating the National Instruments 9230/9232 using Calibration Executive.

Calibration Executive Procedure Features:

Adjustment

Supported
Manual Mode

Supported
Selectable Test Points

Unsupported

Approximate Test Time: 8 minutes

Test Equipment|Test Conditions|Device Setup|Test Limit Equations

Test Equipment

The following table lists the test equipment required for calibrating NI 9230/9232 modules.

Instrument Recommended
Model
Parameter Measured Requirements
Calibrator Fluke 5700A Accuracy, Adjustment If this instrument is unavailable, use a high-precision voltage source with an accuracy ≤100 ppm.
Chassis cDAQ-9178 All

Test Conditions

The following setup and environmental conditions are required to ensure the NI 9230/9232 meets published specifications.

  • Keep connections to the device as short as possible. Long cables and wires act as antennas, picking up extra noise that can affect measurements.
  • Verify that all connections to the device are secure.
  • Use shielded copper wire for all cable connections to the device. Use twisted-pair wire to eliminate noise and thermal offsets.
  • Maintain an ambient temperature of 23 °C ±5 °C. The device temperature will be greater than the ambient temperature.
  • Keep relative humidity below 80%.
  • Allow a warm-up time of at least 10 minutes to ensure that the NI 9230/9232 measurement circuitry is at a stable operating temperature.

Device Setup

  1. Install the NI 9230/9232 in slot 8 of the cDAQ-9178 chassis. Leave slots 1 through 7 on the cDAQ-9178 chassis empty.
  2. Configure the hardware using Measurement & Automation Explorer (MAX).
  3. Launch the Calibration Executive procedure and complete the setup wizard.
Note Note  If the NI 9230/9232 module fails after calibration, return it to NI for repair or replacement.

Test Limit Equations

The following test limits are derived from the published specifications found in the NI 9230/9232 Calibration Procedure.

Analog Voltage Accuracy

TestPointLevel = VoltageAccuracyLimit = TestValue ±((TestValue * GainPercent) + (Offset))

Gain (% of reading) = 0.085%

Offset (% of range) = 0.023%


 

Your Feedback! poor Poor  |  Excellent excellent   Yes No
 Document Quality? 
 Answered Your Question? 
Add Comments 1 2 3 4 5 submit