|NI-RFSG 18.1 Help|
|NI-RFSG 18.2.1 Help|
|NI-RFSG 19.1 Help|
Configures the frequency and power level of the RF output signal. The PXI-5670/5671 and PXIe-5672 device must be in the Configuration state before you call this VI. The PXIe-5644/5645/5646, PXI/PXIe-5650/5651/5652, PXIe-5654/5654 with PXIe-5696, PXIe-5673/5673E, and PXIe-5840 device can be in the Configuration state or Generation state when you call this VI.
Supported Devices: PXIe-5644/5645/5646, PXI/PXIe-5650/5651/5652, PXIe-5654/5654 with PXIe-5696, PXI-5670/5671, PXIe-5672/5673/5673E, PXIe-5840
frequency specifies the frequency of the generated RF signal. For arbitrary waveform generation, frequency specifies the center frequency of the signal. This value is expressed in hertz.
power level specifies the power level of the generated RF signal. By default, this parameter specifies the average power of the signal. To configure the power level of a waveform with varying power, set the Power Level Type property to Peak Power. This value is expressed in dBm.
error in describes error conditions that occur before this node runs. This input provides standard error in functionality.
error out contains error information. This output provides standard error out functionality.
Refer to the following VIs for examples of using the niRFSG Configure RF VI.
• RFSG Getting Started Single Tone Generation VI: labview\examples\instr\niRFSG
• RFSG Frequency Sweep VI: labview\examples\instr\niRFSG
• RFSG Configuration List Frequency and Power Sweep VI: labview\examples\instr\niRFSG