![]() | LabVIEW 2016 FPGA Module Help |
![]() | LabVIEW 2017 FPGA Module Help |
![]() | LabVIEW 2018 FPGA Module Help |
![]() | LabVIEW 2019 FPGA Module Help |
![]() | LabVIEW 2020 FPGA Module Help |
After you create FPGA I/O items in the Project Explorer window, you can use the FPGA I/O items in FPGA I/O Nodes on the block diagram. You can click an FPGA I/O item in the Project Explorer window and drag it onto the block diagram to create a new FPGA I/O Node that is configured for that FPGA I/O item. You also can complete the following steps to add an FPGA I/O Node to the block diagram and configure terminals for specific FPGA I/O items.
You can expand the FPGA I/O Node to add additional FPGA I/O items. Right-click an FPGA I/O item in the FPGA I/O Node and select Add Element from the shortcut menu. A new I/O Item terminal appears in the FPGA I/O Node. You then can repeat step 3 above to configure the new I/O Item terminal.
![]() |
Tip You also can expand the FPGA I/O Node by clicking the upper or lower edge of the node with the Positioning tool and dragging the edge up or down. LabVIEW automatically fills in each additional terminal with FPGA I/O items in the order they appear in the Project Explorer window. You can change the order in which the FPGA I/O items appear in the Project Explorer window prior to expanding the node. In the Project Explorer window, select the FPGA I/O item under the FPGA target and drag it to the position you want it to appear. |
Helpful
Not Helpful