Pipe Radius Property

FlexRIO Help

Edition Date: November 2015

Part Number: 372614J-01

»View Product Info

»Download the Help in ZIP Format

Short Name: PipeRadius

Requires: Base Development System

Class: MultiSegmentPipe Properties

To Use: Create a property.

Gets or sets the radius of the pipe segments in a pipe network. All pipe segments in a pipe network have the same radius.

The pipe radius is the distance, in pixels, between the center of a pipe segment to the edge of the pipe segment. The maximum pipe radius is one pixel less than the radius of the narrowest flange. The radius of a flange is equal to the pipe radius plus the flange width. The minimum pipe radius is five pixels. LabVIEW returns an error if you specify a pipe radius greater than the maximum or less than the minimum pipe radius.

The following illustration shows the pipe radius.

You also can set the pipe radius interactively.

Remarks

The following table lists the characteristics of this property.

Data type
PermissionsRead/Write
Available in Run-Time EngineYes
Available in Real-Time Operating SystemYes
Settable when the VI is runningYes
Loads the front panel into memoryNo
Need to authenticate before useNo
Loads the block diagram into memoryNo
Remote access allowedYes

WAS THIS ARTICLE HELPFUL?

Not Helpful