Short Name: Alarming.U32BitField.SelectMask
Requires: Base Development System
Class: Variable Properties
To Use: Create a property.
Gets or sets which bits LabVIEW uses to calculate the alarm for a shared variable. To use this property, you must install the LabVIEW Datalogging and Supervisory Control Module.
LabVIEW uses bits that are 1 in the alarm calculation. Bits that are 0 do not cause an alarm, regardless of their value. In bitwise terminology, the Shared Variable Engine performs an AND with the select mask value to produce the alarm state. LabVIEW applies the select mask value to the scaled value after applying any relevant scaling masks.
|Note You can enable alarming only for network-published shared variables.|
This property is similar to the Mask option on theAlarming page of the Shared Variable Properties dialog box.
The following table lists the characteristics of this property.
|Available in Run-Time Engine||No|
|Available in Real-Time Operating System||No|
|Settable when the VI is running||Yes|
|Loads the front panel into memory||No|
|Need to authenticate before use||No|
|Loads the block diagram into memory||No|
|Remote access allowed||Yes|