Short Name: Alarming.ROC.Priority
Requires: Base Development System
Class: Variable Properties
To Use: Create a property.
Gets or sets the priority of the Rate of Change alarm for a shared variable. To use this property, you must install the LabVIEW Datalogging and Supervisory Control Module.
Valid values are between 1 and 1000, where 1000 is the highest priority.
|Note You can enable alarming only for network-published shared variables.|
This property is similar to the Priority option on the Alarming page of the Shared Variable Properties dialog box.
The following table lists the characteristics of this property.
|Available in Run-Time Engine||No|
|Available in Real-Time Operating System||No|
|Settable when the VI is running||Yes|
|Loads the front panel into memory||No|
|Need to authenticate before use||No|
|Loads the block diagram into memory||No|
|Remote access allowed||Yes|