Short Name: Auto Err Handling
Requires: Base Development System
Class: VI Properties
To Use: Create a property.
If TRUE, enables automatic error handling for a VI.
By default, LabVIEW automatically handles any error that occurs when a VI runs by suspending execution, highlighting the subVI or function where the error occurred, and displaying an error dialog box.
This property is similar to the Enable automatic error handling in new VIs option on the Block Diagram page of the Options dialog box and the Enable automatic error handling option on the Execution page of the VI Properties dialog box.
|Note The LabVIEW Run-Time Engine does not support automatic error handling.|
The following table lists the characteristics of this property.
|Available in Run-Time Engine||No|
|Available in Real-Time Operating System||No|
|Settable when the VI is running||No|
|Loads the front panel into memory||No|
|Need to authenticate before use||No|
|Loads the block diagram into memory||No|
|Remote access allowed||Yes|
|Must wait until user interface is idle||No|
|Available with control VIs||No|
|Available with global VIs||No|
|Available with strict type definitions||No|
|Available with polymorphic VIs||No|