NI 9250 (FPGA Interface)

NI CompactRIO Device Drivers Help

Edition Date: December 2017

Part Number: 373197L-01

»View Product Info
Download Help (Windows Only)

CompactRIO 2-Ch, ±5 V, 24-Bit, Analog Input Software Selectable IEPE & AC/DC

FPGA I/O Node

You can use an FPGA I/O Node, configured for reading, with this device.

Note  You can synchronize an NI 9250 module with other modules that have a selectable timebase source.

Terminals in Software

Use the FPGA I/O Node to access the following terminals for this device.

Terminal Description
AIx Analog input channel x, where x is the number of the channel. The NI 9250 has channels 0 to 1.
Onboard Clock Gives access to the onboard clock in the LabVIEW block diagram. The onboard clock frequency is 13.1072 MHz. Use the FPGA I/O Node in a single-cycle timed loop to access this channel. You must export the onboard clock of the NI 9250 to access this channel.
Start Channel that controls when the NI 9250 starts acquiring data. If TRUE is written to the Start channel, the NI 9250 starts acquiring data. When the NI 9250 is acquiring data, you must write TRUE to the Stop channel before you can access properties for the module. If FALSE is written to the Start channel, no operation is performed.
Stop Channel that controls when the NI 9250 stops acquiring data. If TRUE is written to the Stop channel, the NI 9250 stops acquiring data. When the NI 9250 is acquiring data, you must write TRUE to the Stop channel before you can access properties for the module. If FALSE is written to the Stop channel, no operation is performed.

Arbitration

This device supports only the Arbitrate if Multiple Requestors Only option for arbitration. You cannot configure arbitration settings for this device.

I/O Properties

Use the FPGA I/O Property Node to access the following I/O properties for this device.

Property Description
Input Configuration Sets the input configuration of the corresponding channel to one of three modes: AC Coupled, DC Coupled, IEPE AC Coupled.

Module Properties

Use the FPGA I/O Property Node to access the following module properties for this device.

Property Description
Data Rate Sets the rate at which the NI 9250 acquires data.
Module ID Returns the module ID, 0x77EA.
Serial Number Returns the unique serial number of the module.
Vendor ID Returns the NI vendor ID, 0x1093.

Single-Cycle Timed Loop

This device does not support the single-cycle Timed Loop.

WAS THIS ARTICLE HELPFUL?

Not Helpful